Prusa3D Forum

Notifications

Clear all

Mike S

Skupina: Registrovaný

Přidal se: 2017/10/29

New Member

	@guy-k2 OK, I did the full reset and went through that whole... In forum Hardware, firmware and software help	před 5 years
	@david-a66 Yes, both the original and the new one both read ... In forum Hardware, firmware and software help	před 5 years
	MK3 was working great, now hot end can't get over about 180 ... In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.4 K Příspěvky

23 Online

69.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed