Notifications
Clear all
Mihai Dinculescu
Skupina: Registrovaný
Přidal se: 2023/01/24
Active Member
1
|
There was debris on the drive gear, but it was on top of it,... In forum Hardware, firmware and software help |
před 3 years | |
|
Extruder gear keeps clicking In forum Hardware, firmware and software help |
před 3 years | |
| It turns out that it was all about first-layer adhesion.The ... | před 3 years | |
| Thank you for the tips. I've run the belt test, and the nu... | před 3 years | |
| Warping and temporary layer shift | před 3 years |