|
Well, after doing some adjustments to get the probe centered... In forum Others (Archive) |
před 8 years |
|
Z axis calibration issue In forum Others (Archive) |
před 8 years |
|
I finished the upgrade with them, and found that they are pl... In forum Others (Archive) |
před 8 years |
|
MK2 Upgrade - End stops (limit switches) In forum Others (Archive) |
před 8 years |
|
Well, I should have looked the error up before posting, but ... In forum Software (Archive) |
před 8 years |
|
I wiped my system and reinstalled a fresh Win10 installation... In forum Software (Archive) |
před 8 years |
|
Ah, very good, thanks for letting me know that. I never ran ... In forum Print tips (Archive) |
před 9 years |
|
Some small issues when printing with PETG In forum Print tips (Archive) |
před 9 years |
|
I don't have under extrusion, as I understand it. I am havin... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Hey roger, yes as I indicated in the post with the blue prin... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Oh, I forgot to mention that a couple of days ago I found th... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Well, I no longer think it has anything to do with the PLA t... In forum Prusa i3 kit (Archive) |
před 9 years |
|
jarred, thanks for the suggestion, but during my initial run... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Since I last posted on this thread, I had received two new s... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Absolutely, I ordered mine on Tuesday. At the time I was tol... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Well, I'm not sure what was causing it but so far I have pri... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Well, that's a no go. I cleaned my glass really well, and th... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Thank you very much guys, I will clean the glass, reapply ju... In forum Prusa i3 kit (Archive) |
před 9 years |
|
Problems with PLA sticking to the print bed In forum Prusa i3 kit (Archive) |
před 9 years |
