Notifications
Clear all
Michael
Michael
Group: Registered
Joined: 2023/03/29
Eminent Member
2
Double check the orientation of the pulleys on the x and y ...

In forum Hardware, firmware and software help

1 month ago
Here’s the Prusa one

In forum General discussion, announcements and releases

2 months ago
That product is for the linear rail the z axis uses the norm...

In forum General discussion, announcements and releases

2 months ago
The nozzle will no longer be heated unnecessarily during fil...

In forum General discussion, announcements and releases

2 months ago
I’m also old xlcd ordered within 2 hours. I was given a trac...

In forum General discussion, announcements and releases

3 months ago
I have the old xLCD and I’m in batch 2 so it can’t be delaye...

In forum General discussion, announcements and releases

4 months ago
I had the problem on a Prusa and also a Samsung USB . I fixe...

In forum General discussion, announcements and releases

7 months ago
I contacted support and asked them to log an issue with the ...

In forum Buddy3D

7 months ago
I also have the same problem. It’s annoying to have this thi...

In forum Buddy3D

7 months ago
I had similar problems and i think the cause was a usb drive...

In forum General discussion, announcements and releases

7 months ago
If you checkout the Auroatech XL video they get slightly bet...

In forum General discussion, announcements and releases

11 months ago
MK4 user comtemplating a XL - what do you use your XL for ?

In forum General discussion, announcements and releases

1 year ago
Hi I abandoned it. It worked but wasn't reliable. There's n...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I have a sock on 5.1.0 with no problems . You have set the m...

In forum Hardware, firmware and software help

2 years ago
The comment about motorcycle shops was supposed to help you ...

In forum General discussion, announcements and releases

2 years ago
I use Plexus - motorcycle shops have it - used for cleaning ...

In forum General discussion, announcements and releases

2 years ago
@fuchsr Can you give some recommendations ?

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Thanks I have a connection for the earth wire using a tab ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I could not find one either. I don't believe there is a crim...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I’ve asked support for the manufacturer and model of the con...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Page 1 / 2
Share: