mgantner – Aktivita – Prusa3D Forum

Notifications

Clear all

mgantner

Skupina: Registrovaný

Přidal se: 2019/01/12

Eminent Member

	Ok, so if that's the case, what would the sensor/hardware fa... In forum PrusaSlicer	před 1 year
	Ty! In forum PrusaSlicer	před 1 year
	Ok, figured out the file posting issue. Gcode attached. If a... In forum Hardware, firmware and software help	před 1 year
	Ok, figured it out, gcode attached a2c3bc0b-test-sta... In forum PrusaSlicer	před 1 year
	Ok, Hopefully there is gcode attached to this post... &nbs... In forum PrusaSlicer	před 1 year
	Glad you reminded me. I forgot that this issue is why I disc... In forum PrusaSlicer	před 1 year
	Yeah, it is zipped. Still not showing In forum PrusaSlicer	před 1 year
	Hmmm, I posted the gcode but it doesn't seem to be there?? A... In forum PrusaSlicer	před 1 year
	No, I simply disconnected the wire connectors from the MMU2 In forum PrusaSlicer	před 1 year
	Unwanted filament changes every print In forum PrusaSlicer	před 1 year
	Unwanted filament changes on every print! In forum Hardware, firmware and software help	před 1 year
	@beni-g I was looking at the wipe tower and I think that the... In forum How do I print this? (Printing help)	před 5 years
	@beni-g Yeah, I'm going to try some different prints to see ... In forum How do I print this? (Printing help)	před 5 years
	@beni-g I've been having problems with PET as well. The wipe... In forum How do I print this? (Printing help)	před 5 years
	A) 30-50 B) 12-15 hrs C) After 10 prints or so, I figured ou... In forum General discussion, announcements and releases	před 5 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

565 Fóra

63.5 K Témata

445.6 K Příspěvky

24 Online

68.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed