Notifiche
Cancella tutti
Max C.
Gruppo: Registrato
Registrato: 2018/12/29
Active Member
1
|
Printer turns off when heatbed/ nozzle are activated Nel forum Hardware, firmware and software help |
4 years fa | |
|
Heat bed thermistor Nel forum Hardware, firmware and software help |
6 years fa | |
| metal tubes for the MMU upgrade | 6 years fa | |
|
i fixed it i heated it up in an oven to 250 *C (to soften th... Nel forum Hardware, firmware a software (Pomoc) |
7 years fa | |
|
Please help filament jam Nel forum Hardware, firmware a software (Pomoc) |
7 years fa | |
| Zaxis problems | 7 years fa | |
| nevermind i fixed it | 7 years fa | |
| i have tested it also by removing the plastic and just using... | 7 years fa | |
| Knob problems | 7 years fa |