Prusa3D Forum

Notifications

Clear all

Matt

Grupa: Zarejestrowany

Dołączył: 2020/08/31

Active Member

	Consistent Extrusion Issue In forum How do I print this? (Printing help)	4 years temu
	For getting the filament out you can try undoing the spring ... In forum Hardware, firmware and software help	4 years temu
	My first recommendation would be to check for kinks/pinch po... In forum Hardware, firmware and software help	4 years temu
	How does the filament look after it attempting to extrude? I... In forum Hardware, firmware and software help	4 years temu
	Check to see if retraction is on, try printing it without; i... In forum Hardware, firmware and software help	4 years temu
	Streaking? Extruder? Power supply? Controller? Slic3r? Other... In forum Hardware, firmware and software help	4 years temu

Statystyki Forum

565 Fora

63.5 K Tematy

446 K Posty

20 Online

68.8 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte