Prusa3D Forum

Notifications

Clear all

Matt

Skupina: Registrovaný

Přidal se: 2020/08/31

Active Member

	Consistent Extrusion Issue In forum How do I print this? (Printing help)	před 4 years
	For getting the filament out you can try undoing the spring ... In forum Hardware, firmware and software help	před 4 years
	My first recommendation would be to check for kinks/pinch po... In forum Hardware, firmware and software help	před 4 years
	How does the filament look after it attempting to extrude? I... In forum Hardware, firmware and software help	před 4 years
	Check to see if retraction is on, try printing it without; i... In forum Hardware, firmware and software help	před 4 years
	Streaking? Extruder? Power supply? Controller? Slic3r? Other... In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

565 Fóra

63.5 K Témata

446 K Příspěvky

20 Online

68.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed