Prusa3D Forum

Notifications

Clear all

Matt

Group: Registered

Joined: 2020/08/31

Active Member

	Consistent Extrusion Issue In forum How do I print this? (Printing help)	4 years ago
	For getting the filament out you can try undoing the spring ... In forum Hardware, firmware and software help	4 years ago
	My first recommendation would be to check for kinks/pinch po... In forum Hardware, firmware and software help	4 years ago
	How does the filament look after it attempting to extrude? I... In forum Hardware, firmware and software help	4 years ago
	Check to see if retraction is on, try printing it without; i... In forum Hardware, firmware and software help	4 years ago
	Streaking? Extruder? Power supply? Controller? Slic3r? Other... In forum Hardware, firmware and software help	4 years ago

Forum Statistics

565 Forums

63.5 K Topics

446 K Posts

21 Online

68.8 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed