Notifications
Clear all
Mataos
Skupina: Registrovaný
Přidal se: 2021/03/01
Active Member
1
|
The solution for this issue was that the filament wasn't bei... In forum Hardware, firmware and software help |
před 4 years | |
|
Filament not loading In forum Hardware, firmware and software help |
před 4 years | |
|
@antonio-da-catania Thank you, problem solved! In forum PrusaSlicer |
před 4 years | |
|
Prusa Slicer MINI+ system In forum PrusaSlicer |
před 4 years | |
| @turro75 Thank you Turro, ended up going back through the bo... | před 4 years | |
| @turro75 No success, same issue. Pulled it up about halfway,... | před 4 years | |
| @turro75 How do I raise the z axis? Sorry, very new to this,... | před 4 years | |
| Prusa Mini+ Failing Initial Testing (XYZ Axis) | před 4 years |