Benachrichtigungen
Alles löschen
Mat
Gruppe: Registriert
Beigetreten: 2020/10/20
Active Member
1
| Ahh ok but you could of said it in a more friendlier way. | Vor 5 years | |
| Have you not paid VAT on purchase to Prusa? | Vor 5 years | |
| OctoPi Bed Visualiser | Vor 5 years | |
| Ouch, was just going to order a new steel sheet and some Pru... | Vor 5 years | |
| This was it. I undid the 3 little screws and moved up the ho... | Vor 5 years | |
| I followed the guide for the extruder removal and clean and ... | Vor 5 years | |
| I've done cold pulls and that did not work and the I noticed... | Vor 5 years | |
| I've just read the Prusa guide and the screw is flush as it ... | Vor 5 years | |
| Swapped to SuperPINDA and worse prints, extruder click? | Vor 5 years | |
|
Thanks, found I had to set the 5000 port in the Add-on confi... Im Forum PrusaSlicer |
Vor 5 years | |
|
@gordon-w its full Octoprint in HA, its not a card that moni... Im Forum PrusaSlicer |
Vor 5 years | |
|
@karl-herbert Hello. Yes I added the API as well, but readin... Im Forum PrusaSlicer |
Vor 5 years | |
|
Slicer Connect to OctoPrint on HomeAssistant Im Forum PrusaSlicer |
Vor 5 years |