Notifications
Clear all
Mat
Skupina: Registrovaný
Přidal se: 2020/10/20
Active Member
1
Ahh ok but you could of said it in a more friendlier way. | před 4 years | |
Have you not paid VAT on purchase to Prusa? | před 4 years | |
OctoPi Bed Visualiser | před 4 years | |
Ouch, was just going to order a new steel sheet and some Pru... | před 4 years | |
This was it. I undid the 3 little screws and moved up the ho... | před 4 years | |
I followed the guide for the extruder removal and clean and ... | před 4 years | |
I've done cold pulls and that did not work and the I noticed... | před 4 years | |
I've just read the Prusa guide and the screw is flush as it ... | před 4 years | |
Swapped to SuperPINDA and worse prints, extruder click? | před 4 years | |
Thanks, found I had to set the 5000 port in the Add-on confi... In forum PrusaSlicer |
před 4 years | |
@gordon-w its full Octoprint in HA, its not a card that moni... In forum PrusaSlicer |
před 4 years | |
@karl-herbert Hello. Yes I added the API as well, but readin... In forum PrusaSlicer |
před 4 years | |
Slicer Connect to OctoPrint on HomeAssistant In forum PrusaSlicer |
před 4 years |