Prusa3D Forum

Notifications

Clear all

Marek Lewandowski

Group: Registered

Joined: 2016/09/18

Active Member

	Wow. After three months someone noticed that issue at github... In forum Improvements (Archive)	8 years ago
	Wow. After three months someone noticed that issue at github... In forum Improvements (Archive)	8 years ago
	first time on this forum and I came looking for this very in... In forum Improvements (Archive)	8 years ago
	Serious? There really is not much logic in that statement, b... In forum Improvements (Archive)	8 years ago
	Firmware allows Z to go to 210, which is 9mm higher than it ... In forum Improvements (Archive)	8 years ago
	The current start code in Slic3r is this: M115 U3.0.9 ; tel... In forum Improvements (Archive)	8 years ago
	I can see why you think I missed the point, but I did not. ... In forum Improvements (Archive)	8 years ago
	This lifts the extruder to the top middle, where it is easy ... In forum Improvements (Archive)	8 years ago
	Can you open an issue ticket in the GitHub repo for the firm... In forum Improvements (Archive)	8 years ago
	And one more notice. Depending on bed and hotend target temp... In forum Improvements (Archive)	8 years ago
	Just a notice. If you do home all axes with cold nozzle and ... In forum Improvements (Archive)	8 years ago
	PINDA probe, live Z calibration, Z-offset and temperature In forum Improvements (Archive)	8 years ago

Forum Statistics

565 Forums

63.6 K Topics

446.2 K Posts

20 Online

68.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed