English
Forums
Members
MarcWinNJ
Activity
 
Notifications
Clear all
MarcWinNJ
MarcWinNJ
Group: Registered
Joined: 2020/12/20
Active Member
1
Profile Activity
I just moved it around near the filament feed, top center of...

In forum Hardware, firmware and software help

 2 years ago
That was the first thing I tried. I read elsewhere here abo...

In forum Hardware, firmware and software help

 2 years ago
Have to be honest here and I hope Prusa support is in this f...

In forum Hardware, firmware and software help

 2 years ago
You dont have an MK4 do you?

In forum Input Shaper (MK4)

 2 years ago
The whole point of the MK4 is to not deal with Live Z. The i...

In forum Input Shaper (MK4)

 2 years ago
It is a file naming issue. Prusa Connect rejects sending du...

In forum Bugs & Errors

 2 years ago
Cleaning the slight ooze and pulling the newer roll loose a ...

In forum Input Shaper (MK4)

 2 years ago
I figured this out to be that the system will not allow you ...

In forum Bugs & Errors

 2 years ago
Prusa Connect fails to upload to the MK4 - some file not all

In forum Bugs & Errors

 2 years ago
Is the WIFI disconnect issue fixed in this release.

In forum Input Shaper (MK4)

 2 years ago
Any idea on when we will see an update. Seems like the Alpha...

In forum Input Shaper (MK4)

 2 years ago
I am going through the same issues. In fact my MK3S+ has nev...

In forum Assembly and first prints troubleshooting

 3 years ago
Did you ever figure out how to do this on a Mac

In forum PrusaSlicer

 3 years ago
I found it am am in, thanks for the feedback

In forum General discussion, announcements and releases

 5 years ago
How do you get support from Prusa - live chat - does ti exis...

In forum General discussion, announcements and releases

 5 years ago
Share: