Italiano
Forum
Utenti
MakingThingsCLT
Attività
 
Notifiche
Cancella tutti
MakingThingsCLT
MakingThingsCLT
Gruppo: Registrato
Registrato: 2017/09/11
Active Member
1
Profilo Attività
WHOOPS! When I swapped the motor I used a new toothed pulley...

Nel forum Hardware, firmware and software help

 5 years fa
Replaced X-axis motor on a MK2.5 and the E-steps are clearly...

Nel forum Hardware, firmware and software help

 5 years fa
M112 Emergency Stop, no signs of problems otherwise

Nel forum Hardware, firmware and software help

 5 years fa
I'm having the same problem. Old gcode that turns the fan on...

Nel forum Assembly and first prints troubleshooting

 6 years fa
Looks like it was the filament sensor. 3D Solutech PLA has a...

Nel forum Hardware, firmware and software help

 7 years fa
Thanks, that's good to know. Someone else pointed out that t...

Nel forum Hardware, firmware and software help

 7 years fa
Random M600 calls that are not in gcode

Nel forum Hardware, firmware and software help

 7 years fa
Temperature gets set to 0 mid print?

Nel forum Others (Archive)

 8 years fa
Wiring and Cable Management Tips?

Nel forum Prusa i3 kit (Archive)

 8 years fa
Prusa Control stalls out during gcode export

Nel forum Software (Archive)

 8 years fa
... I thought about doing something like this. Don't you hav...

Nel forum Others (Archive)

 8 years fa
I'm somewhat ashamed that it took me this long to realize th...

Nel forum Awesome prints (Hall Of Fame)

 8 years fa
I had the same problem the other day. It was really bad; the...

Nel forum Others (Archive)

 8 years fa
it's a common problem at many builds, that the cable trunk i...

Nel forum Others (Archive)

 8 years fa
Does Sketchup still produce terrible non-manifold meshes? It...

Nel forum Others (Archive)

 8 years fa
Condividi: