English
Forums
Members
MakingThingsCLT
Activity
 
Notifications
Clear all
MakingThingsCLT
MakingThingsCLT
Group: Registered
Joined: 2017/09/11
Active Member
1
Profile Activity
WHOOPS! When I swapped the motor I used a new toothed pulley...

In forum Hardware, firmware and software help

 5 years ago
Replaced X-axis motor on a MK2.5 and the E-steps are clearly...

In forum Hardware, firmware and software help

 5 years ago
M112 Emergency Stop, no signs of problems otherwise

In forum Hardware, firmware and software help

 5 years ago
I'm having the same problem. Old gcode that turns the fan on...

In forum Assembly and first prints troubleshooting

 6 years ago
Looks like it was the filament sensor. 3D Solutech PLA has a...

In forum Hardware, firmware and software help

 7 years ago
Thanks, that's good to know. Someone else pointed out that t...

In forum Hardware, firmware and software help

 7 years ago
Random M600 calls that are not in gcode

In forum Hardware, firmware and software help

 7 years ago
Temperature gets set to 0 mid print?

In forum Others (Archive)

 8 years ago
Wiring and Cable Management Tips?

In forum Prusa i3 kit (Archive)

 8 years ago
Prusa Control stalls out during gcode export

In forum Software (Archive)

 8 years ago
... I thought about doing something like this. Don't you hav...

In forum Others (Archive)

 8 years ago
I'm somewhat ashamed that it took me this long to realize th...

In forum Awesome prints (Hall Of Fame)

 8 years ago
I had the same problem the other day. It was really bad; the...

In forum Others (Archive)

 8 years ago
it's a common problem at many builds, that the cable trunk i...

In forum Others (Archive)

 8 years ago
Does Sketchup still produce terrible non-manifold meshes? It...

In forum Others (Archive)

 8 years ago
Share: