Notifications
Clear all
makern3rd
Grupa: Zarejestrowany
Dołączył: 2018/10/26
Active Member
1
|
XYZ calibration cube In forum How do I print this? (Printing help) |
5 years temu | |
| Thanks for the reply. This is the Benchy that came with the ... | 6 years temu | |
| Benchy issues | 6 years temu | |
| TL;DR; - fixed the door shaft and re-did idler door tension ... | 6 years temu | |
| Yes, it is the MK3_PLA_Treefrog_50um_3H_40M.gcode file from... | 6 years temu | |
| Ok, I fixed the door and shaft, I replaced the nozzle with a... | 6 years temu | |
| OK, so 0.05mm countless attempts with the frog from the SD a... | 6 years temu | |
| Endless cold pulls later, my extruder still clogs when I try... | 6 years temu | |
|
I have the same problem, the printer pauses and says "heatin... In forum Hardware, firmware and software help |
6 years temu | |
| My problem is the fact the it clogs on 0.05mm. I tried last... | 6 years temu | |
| Mk3 treefrog 50 microns clog | 6 years temu |