Notifications
Clear all
makern3rd
Group: Registered
Joined: 2018/10/26
Active Member
1
XYZ calibration cube In forum How do I print this? (Printing help) |
5 years ago | |
Thanks for the reply. This is the Benchy that came with the ... | 6 years ago | |
Benchy issues | 6 years ago | |
TL;DR; - fixed the door shaft and re-did idler door tension ... | 6 years ago | |
Yes, it is the MK3_PLA_Treefrog_50um_3H_40M.gcode file from... | 6 years ago | |
Ok, I fixed the door and shaft, I replaced the nozzle with a... | 6 years ago | |
OK, so 0.05mm countless attempts with the frog from the SD a... | 6 years ago | |
Endless cold pulls later, my extruder still clogs when I try... | 6 years ago | |
I have the same problem, the printer pauses and says "heatin... In forum Hardware, firmware and software help |
6 years ago | |
My problem is the fact the it clogs on 0.05mm. I tried last... | 6 years ago | |
Mk3 treefrog 50 microns clog | 6 years ago |