Prusa3D Forum

Notifiche

Cancella tutti

Madscientist57

Gruppo: Registrato

Registrato: 2024/02/19

Active Member

	Thanks much. Really it would be pretty cool if I printed a ... Nel forum Hardware, firmware and software help	10 months fa
	Sounds good, I'll give it a try. What's the worst that can ... Nel forum Hardware, firmware and software help	10 months fa
	Orca slicer- can I use MK3S configuration for my MK3? Nel forum Hardware, firmware and software help	10 months fa
	Well. I got on chat with someone at Prusa, thanks for sugge... Nel forum Hardware, firmware and software help	11 months fa
	Ok, thanks everyone. I'm new to this, I didn't think of goi... Nel forum Hardware, firmware and software help	11 months fa
	Ok, related question. I sliced a model with the Prusa slice... Nel forum Hardware, firmware and software help	11 months fa
	Thanks Crab. Yes, I mistyped. I'm getting the same non-res... Nel forum Hardware, firmware and software help	11 months fa
	I'm still stuck. I reflashed the firmware back to 1.13.0 an... Nel forum Hardware, firmware and software help	11 months fa
	Keeps saying 'printer has not been calibrated yet' and refus... Nel forum Hardware, firmware and software help	11 months fa

Statistiche Forum

565 Forum

64.2 K Discussioni

449.4 K Post

17 Online

70.3 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso