|
Thanks much. Really it would be pretty cool if I printed a ... En el foro Hardware, firmware and software help |
hace 10 months |
|
Sounds good, I'll give it a try. What's the worst that can ... En el foro Hardware, firmware and software help |
hace 10 months |
|
Orca slicer- can I use MK3S configuration for my MK3? En el foro Hardware, firmware and software help |
hace 10 months |
|
Well. I got on chat with someone at Prusa, thanks for sugge... En el foro Hardware, firmware and software help |
hace 11 months |
|
Ok, thanks everyone. I'm new to this, I didn't think of goi... En el foro Hardware, firmware and software help |
hace 11 months |
|
Ok, related question. I sliced a model with the Prusa slice... En el foro Hardware, firmware and software help |
hace 11 months |
|
Thanks Crab. Yes, I mistyped. I'm getting the same non-res... En el foro Hardware, firmware and software help |
hace 11 months |
|
I'm still stuck. I reflashed the firmware back to 1.13.0 an... En el foro Hardware, firmware and software help |
hace 11 months |
|
Keeps saying 'printer has not been calibrated yet' and refus... En el foro Hardware, firmware and software help |
hace 11 months |
