Notifications
Clear all
Lunchbox
Skupina: Registrovaný
Přidal se: 2017/10/12
Active Member
1
|
Low voltage electronic components often melt and release "ma... In forum Hardware, firmware and software help |
před 6 years | |
| Perfect thanks! I also see today there was a config update f... | před 6 years | |
| soluble supports in MMU 2.0 | před 6 years | |
|
Mine would make a horrible noise not only while extruding, b... In forum Others (Archive) |
před 7 years | |
|
Mine had the same issue. I tried everything. I finally found... In forum Others (Archive) |
před 7 years | |
|
you guys were right, i ended up readjusting Z again and it i... In forum Others (Archive) |
před 7 years | |
|
you guys were right, i ended up readjusting Z again and it i... In forum Others (Archive) |
před 7 years | |
|
I did a Z calibration right before this print. How is my z h... In forum Others (Archive) |
před 7 years | |
|
First layer issues In forum Others (Archive) |
před 7 years |