Notifications
Clear all
Lunchbox
Group: Registered
Joined: 2017/10/12
Active Member
1
Low voltage electronic components often melt and release "ma... In forum Hardware, firmware and software help |
6 years ago | |
Perfect thanks! I also see today there was a config update f... | 6 years ago | |
soluble supports in MMU 2.0 | 6 years ago | |
Mine would make a horrible noise not only while extruding, b... In forum Others (Archive) |
7 years ago | |
Mine had the same issue. I tried everything. I finally found... In forum Others (Archive) |
7 years ago | |
you guys were right, i ended up readjusting Z again and it i... In forum Others (Archive) |
7 years ago | |
you guys were right, i ended up readjusting Z again and it i... In forum Others (Archive) |
7 years ago | |
I did a Z calibration right before this print. How is my z h... In forum Others (Archive) |
7 years ago | |
First layer issues In forum Others (Archive) |
7 years ago |