Prusa3D Forum

Notifiche

Cancella tutti

Lucas G.

Gruppo: Registrato

Registrato: 2019/12/19

Active Member

	I could not find Layerneer easily so I have tried with Dima... Nel forum How do I print this? (Printing help)	4 years fa
	Thank you all for a lot of valuable information. I have trie... Nel forum How do I print this? (Printing help)	4 years fa
	PC Blend - trying to print extruder Nel forum How do I print this? (Printing help)	4 years fa
	Of course I meant electric oven with good thermostat. I thou... Nel forum General discussion, announcements and releases	4 years fa
	If you have a reasonable modern oven I would use that. I hav... Nel forum General discussion, announcements and releases	4 years fa
	I have forgotten that I posted here. Problem is solved alrea... Nel forum General discussion, announcements and releases	4 years fa
	"Branches" growing off of the print. Nel forum General discussion, announcements and releases	4 years fa
	Need trusted 0.5 mm nozzle profile Nel forum Hardware, firmware and software help	5 years fa

Statistiche Forum

566 Forum

63.2 K Discussioni

444.2 K Post

24 Online

68.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso