Prusa3D Forum

Notifications

Clear all

Lucas G.

Groupe: Enregistré

A(ont) rejoint: 2019/12/19

Active Member

	Prusa MK3S+, newest firmware, RPi port, No LAN access Dans le forum Hardware, firmware and software help	il y a 2 months
	I could not find Layerneer easily so I have tried with Dima... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Thank you all for a lot of valuable information. I have trie... Dans le forum How do I print this? (Printing help)	il y a 4 years
	PC Blend - trying to print extruder Dans le forum How do I print this? (Printing help)	il y a 4 years
	Of course I meant electric oven with good thermostat. I thou... Dans le forum General discussion, announcements and releases	il y a 5 years
	If you have a reasonable modern oven I would use that. I hav... Dans le forum General discussion, announcements and releases	il y a 5 years
	I have forgotten that I posted here. Problem is solved alrea... Dans le forum General discussion, announcements and releases	il y a 5 years
	"Branches" growing off of the print. Dans le forum General discussion, announcements and releases	il y a 5 years
	Need trusted 0.5 mm nozzle profile Dans le forum Hardware, firmware and software help	il y a 5 years

Statistiques du forum

565 Forums

64.6 K Sujets

452.2 K Messages

20 En-ligne

71.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé