Notifications
Clear all
lonelymonk
lonelymonk
Skupina: Registrovaný
Přidal se: 2020/10/28
Eminent Member
2
So, what is left to check??All I can think of is a pinched (...

In forum Assembly and first prints troubleshooting

před 4 years
I check the E-Motor cable, not kinks or breaks. Check it's c...

In forum Assembly and first prints troubleshooting

před 4 years
Did the filament sensor troubleshooting.The sensor is workin...

In forum Assembly and first prints troubleshooting

před 4 years
RE: Filament Auto Feed, filament sensor, E-Motor...?????

In forum Assembly and first prints troubleshooting

před 4 years
Is it the zero right above the MK3S?

In forum Assembly and first prints troubleshooting

před 4 years
I don't see a one for zero where should it be

In forum Assembly and first prints troubleshooting

před 4 years
I don't see a one for zero where should it be

In forum Assembly and first prints troubleshooting

před 4 years
@karl-herbert Thank you

In forum Assembly and first prints troubleshooting

před 4 years
Filament Auto Feed, filament sensor, E-Motor...?????

In forum Assembly and first prints troubleshooting

před 4 years
Auto load filament?

In forum Assembly and first prints troubleshooting

před 4 years
PINDA z sensor cable was sticking out, rerouted it all good

In forum Assembly and first prints troubleshooting

před 4 years
self test error, axis length X

In forum Assembly and first prints troubleshooting

před 4 years
filament extruder tension screw loosened. Wrong size bolt re...

In forum Assembly and first prints troubleshooting

před 4 years
I'm looking thru the book, can't find "filament extruder ten...

In forum Assembly and first prints troubleshooting

před 4 years
Thanks

In forum Assembly and first prints troubleshooting

před 4 years
Oooops, "I pretty sure I did put in the wrong size screw.."...

In forum Assembly and first prints troubleshooting

před 4 years
Assembly Original Prusa i3 MK3S kit, 3 X-Axis assembly, Step...

In forum Assembly and first prints troubleshooting

před 4 years
Stránka 2 / 2
Share: