Prusa3D Forum

Notifications

Clear all

Logicwax

Groupe: Enregistré

A(ont) rejoint: 2024/01/26

Active Member

	I received a new xBuddy board from prusa support, and once I... Dans le forum Hardware, firmware and software help	il y a 10 months
	I spoke too soon. Next day after a few prints, the same i... Dans le forum Hardware, firmware and software help	il y a 10 months
	I had the same exact issue, and support told me it was a fir... Dans le forum Hardware, firmware and software help	il y a 10 months
	Update: I solved my issue! Turns out it was a defective hot... Dans le forum Hardware, firmware and software help	il y a 10 months
	Update: I solved my issue!Turns out it was a defective hote... Dans le forum Hardware, firmware and software help	il y a 10 months
	Also, I just noticed that you don't necessarily have to pre-... Dans le forum Hardware, firmware and software help	il y a 10 months
	I have this same issue. Pre-heating is the only solution th... Dans le forum Hardware, firmware and software help	il y a 10 months
	I have the same issue. Prusa support confirmed this is a fi... Dans le forum Hardware, firmware and software help	il y a 10 months

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

22 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé