|
Most likely its the coreXY design. To move in a straight l... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
Looking at the 6.3.1 tag, I also see that phase stepping loo... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
The mod that darksharpie posted is brilliant. I installed... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
Yep same issues here. Definitely a firmware issue. Can’t... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
For anyone tuning in, the non-coreXY I was referring to in m... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
Ah! Thanks for pointing that out. This whole time I thoug... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
No, there are core-XY's that don't use this gantry design. ... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
Core One giant let down from mk4s+. VFAs, resonance sounds, ... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
I have VFA's too on my core one (as well as the ugly soundin... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
I'm having the same issues. Really bad sounding resonance.... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
I'm having the same issue Im Forum Hardware, firmware and software help |
Vor 11 months |
|
I received a new xBuddy board from prusa support, and once I... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I spoke too soon. Next day after a few prints, the same i... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I had the same exact issue, and support told me it was a fir... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
Update: I solved my issue! Turns out it was a defective hot... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
Update: I solved my issue!Turns out it was a defective hote... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
Also, I just noticed that you don't necessarily have to pre-... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I have this same issue. Pre-heating is the only solution th... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I have the same issue. Prusa support confirmed this is a fi... Im Forum Hardware, firmware and software help |
Vor 2 years |
