|
Most likely its the coreXY design. To move in a straight l... In forum Hardware, firmware and software help |
8 months ago |
|
Looking at the 6.3.1 tag, I also see that phase stepping loo... In forum Hardware, firmware and software help |
8 months ago |
|
The mod that darksharpie posted is brilliant. I installed... In forum Hardware, firmware and software help |
9 months ago |
|
Yep same issues here. Definitely a firmware issue. Can’t... In forum Hardware, firmware and software help |
9 months ago |
|
For anyone tuning in, the non-coreXY I was referring to in m... In forum Hardware, firmware and software help |
10 months ago |
|
Ah! Thanks for pointing that out. This whole time I thoug... In forum Hardware, firmware and software help |
10 months ago |
|
No, there are core-XY's that don't use this gantry design. ... In forum Hardware, firmware and software help |
10 months ago |
|
Core One giant let down from mk4s+. VFAs, resonance sounds, ... In forum Hardware, firmware and software help |
10 months ago |
|
I have VFA's too on my core one (as well as the ugly soundin... In forum Hardware, firmware and software help |
10 months ago |
|
I'm having the same issues. Really bad sounding resonance.... In forum Hardware, firmware and software help |
10 months ago |
|
I'm having the same issue In forum Hardware, firmware and software help |
10 months ago |
|
I received a new xBuddy board from prusa support, and once I... In forum Hardware, firmware and software help |
2 years ago |
|
I spoke too soon. Next day after a few prints, the same i... In forum Hardware, firmware and software help |
2 years ago |
|
I had the same exact issue, and support told me it was a fir... In forum Hardware, firmware and software help |
2 years ago |
|
Update: I solved my issue! Turns out it was a defective hot... In forum Hardware, firmware and software help |
2 years ago |
|
Update: I solved my issue!Turns out it was a defective hote... In forum Hardware, firmware and software help |
2 years ago |
|
Also, I just noticed that you don't necessarily have to pre-... In forum Hardware, firmware and software help |
2 years ago |
|
I have this same issue. Pre-heating is the only solution th... In forum Hardware, firmware and software help |
2 years ago |
|
I have the same issue. Prusa support confirmed this is a fi... In forum Hardware, firmware and software help |
2 years ago |
