Français
Forums
Membres
loadinglevelone
Activité
 
Notifications
Clear all
loadinglevelone
loadinglevelone
Groupe: Enregistré
A(ont) rejoint: 2020/01/06
Trusted Member
3
Profil Activité
Could bed temp be the reason why larger object are not stick...

Dans le forum General discussion, announcements and releases

 il y a 5 years
This is a common problem and unfortunately often overlooked ...

Dans le forum How do I print this? (Printing help)

 il y a 5 years
I've done prints like this tons of times. Never had a proble...

Dans le forum How do I print this? (Printing help)

 il y a 5 years
Im not quite following you. You say that the solution is: - ...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
Yeah, usually end up using just the generic PLA/PETG profil...

Dans le forum PrusaSlicer

 il y a 6 years
@jsw I might be mistaken, but I think Prusa filament is what...

Dans le forum PrusaSlicer

 il y a 6 years
No difference between filament profiles

Dans le forum PrusaSlicer

 il y a 6 years
Update: The day after this happened, the live z value was ba...

Dans le forum Hardware, firmware and software help

 il y a 6 years
OK now I'm even more confused. Changed fro smooth sheet to s...

Dans le forum Hardware, firmware and software help

 il y a 6 years
Live Z suddenly changed for no reason.

Dans le forum Hardware, firmware and software help

 il y a 6 years
Listen at 5s and 9s of this video It only happens on the st...

Dans le forum Hardware, firmware and software help

 il y a 6 years
Loud Noise from printer at the start of every print.

Dans le forum Hardware, firmware and software help

 il y a 6 years
What are the drawbacks of silent mode?

Dans le forum General discussion, announcements and releases

 il y a 6 years
Page 3 / 3
Partager :