Notifications
Clear all
Lain Szvahl
Groupe: Enregistré
A(ont) rejoint: 2019/05/27
Active Member
1
|
might suspect that its the G4 S10; wait for heaters to recov... Dans le forum General discussion, announcements and releases |
il y a 6 years | |
|
thats odd cause i dont have a M109 in my Filament GCODE this... Dans le forum General discussion, announcements and releases |
il y a 6 years | |
|
alright here is the gcode! nana2_1 im not very good at looki... Dans le forum General discussion, announcements and releases |
il y a 6 years | |
|
Just to note this happens only with prusa Slicer 2.0, not wi... Dans le forum General discussion, announcements and releases |
il y a 6 years | |
|
PrusaSlicer 2.0 - Hot end not heating up? Dans le forum General discussion, announcements and releases |
il y a 6 years |