Prusa3D Forum

Notifications

Clear all

LaForg3

Skupina: Registrovaný

Přidal se: 2021/05/01

Active Member

	I think Prusa should rather work on their current assembly p... In forum Hardware, firmware and software help	před 12 months
	Thanks for the reply. This is not about reassigning extruder... In forum Hardware, firmware and software help	před 12 months
	Extrusion Multiplier versus Custom "Before layer change G-co... In forum How do I print this? (Printing help)	před 12 months
	XL Multitool Underextrusion on specific toolhead In forum Hardware, firmware and software help	před 12 months
	I fixed the little "dots" of filament by reducing the temper... In forum General discussion, announcements and releases	před 12 months
	Extruder Print Order (Multi-Tool) In forum Hardware, firmware and software help	před 12 months
	Thanks had the exact same issue. Magnet on Picture 2 was put... In forum Hardware, firmware and software help	před 12 months
	Prusament PETG out of stock In forum General discussion, announcements and releases	před 3 years
	@ssill2 Thank your very much for your answer. So PETG prints... In forum How do I print this? (Printing help)	před 3 years
	Prusament PETG using enclosure for health reasons? In forum How do I print this? (Printing help)	před 3 years
	@diem Thank you very much for your answer. I will give the r... In forum General discussion, announcements and releases	před 4 years
	Question about newest Blog Article on Waterproof 3D Prints In forum General discussion, announcements and releases	před 4 years

Fórum Statistiky

559 Fóra

62.8 K Témata

442.4 K Příspěvky

20 Online

67.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed