Notifications
Clear all
LadyOfCogs
Skupina: Registrovaný
Přidal se: 2021/10/25
Active Member
1
|
I forgot to add - I switched off the 3d printer after it sta... In forum Hardware, firmware and software help |
před 12 months | |
|
System restarts after moving to enclosure - reconnect cables... In forum Hardware, firmware and software help |
před 12 months | |
| Extrusion problems | před 3 years | |
|
The nozzle seems to be stuck (it rotates when heated to 285 ... In forum Hardware, firmware and software help |
před 3 years | |
|
Unfortunately when I was screwing the nozzle after I reattem... In forum Hardware, firmware and software help |
před 3 years | |
|
I did try this today despite it being not recommended for No... In forum Hardware, firmware and software help |
před 3 years | |
|
I forgot to add - it's not first layer problem. It happened ... In forum Hardware, firmware and software help |
před 3 years | |
|
Extrusion problem (due to extruder tention?) after reassembl... In forum Hardware, firmware and software help |
před 3 years |