Notifications
Clear all
kpmoody
Skupina: Registrovaný
Přidal se: 2023/05/21
Active Member
1
| After trying to print some cubes I saw that I had a bad Y ax... | před 2 years | |
| Latest full print. As you can see, weird gap in top perimete... | před 2 years | |
| Leveled again and it seems better overall, I was too low I t... | před 2 years | |
| Does it look too high or low? | před 2 years | |
| I've done that, I ran the setup wizard. | před 2 years | |
| Just trying to get this up and running again after it has be... | před 2 years | |
| Bed Level Correction Test Print | před 2 years |