Avisos
Vaciar todo
KnightKap
Grupo: Registrado
Registrado: 2018/09/06
Active Member
1
|
done. Issue #3043 Thanks again. En el foro PrusaSlicer |
hace 6 years | |
|
Yes! Thanks! I did not think of that. Split into parts pro... En el foro PrusaSlicer |
hace 6 years | |
|
Incorrectly reading STL during slice? En el foro PrusaSlicer |
hace 6 years | |
|
I think this is ok, no? not sure why they are upside down th... En el foro Assembly and first prints troubleshooting |
hace 6 years | |
| Thanks. Washed the plate quite thoroughly with dish soap. ... | hace 6 years | |
| Using PLA. Some of the pieces curling off the sheet and then... | hace 6 years | |
| Why Dawn specifically? Does it matter? I have this sheet (V... | hace 6 years |