Notifications
Clear all
KnightKap
Group: Registered
Joined: 2018/09/06
Active Member
1
|
done. Issue #3043 Thanks again. In forum PrusaSlicer |
6 years ago | |
|
Yes! Thanks! I did not think of that. Split into parts pro... In forum PrusaSlicer |
6 years ago | |
|
Incorrectly reading STL during slice? In forum PrusaSlicer |
6 years ago | |
| I think this is ok, no? not sure why they are upside down th... | 6 years ago | |
| Thanks. Washed the plate quite thoroughly with dish soap. ... | 6 years ago | |
| Using PLA. Some of the pieces curling off the sheet and then... | 6 years ago | |
| Why Dawn specifically? Does it matter? I have this sheet (V... | 6 years ago |