Aktywność
 
Notifications
Clear all
Kevlad
Kevlad
Grupa: Zarejestrowany
Dołączył: 2018/07/02
Eminent Member
2
Hi AMV, I started another thread about underextrusion of fil...

In forum Hardware, firmware and software help

4 months temu
Hi Diem - no, no, no and nope.... 🤣 Im going to mark this ...

In forum Hardware, firmware and software help

5 months temu
Thanks Eef - I had the extruder in pieces earlier and I doub...

In forum Hardware, firmware and software help

5 months temu
Quick update.... if I disconnect the PTFE tube from its con...

In forum Hardware, firmware and software help

5 months temu
Underextrusion issue

In forum Hardware, firmware and software help

5 months temu
Thanks W-Sand. I took the filament sensor apart today and d...

In forum Hardware, firmware and software help

6 months temu
That sounds promising….. I did some experiments today to ...

In forum Hardware, firmware and software help

6 months temu
@w sand - did you get to the bottom of the problem? I’m expe...

In forum Hardware, firmware and software help

6 months temu
OK - found the problem..... I noticed that within slicer, t...

In forum Hardware, firmware and software help

7 months temu
Final test - Parked both heads. Changed slicer to print fro...

In forum Hardware, firmware and software help

7 months temu
Update I parked tool 2 and loaded tool 1 before sending the ...

In forum Hardware, firmware and software help

7 months temu
XL using wrong tool - settings?

In forum Hardware, firmware and software help

7 months temu
I just did a quick test with adding the 2 stage heat up proc...

In forum General discussion, announcements and releases

5 years temu
I think it has started since I last upgraded the f/w but Im ...

In forum General discussion, announcements and releases

5 years temu
Bed level before print leaving material on print bed

In forum General discussion, announcements and releases

5 years temu
I may have found the issue. I was using octoprint on an o...

In forum Others (Archive)

6 years temu
Outer wall issue on circles......

In forum Others (Archive)

6 years temu
Share: