|
Hi AMV, I started another thread about underextrusion of fil... Dans le forum Hardware, firmware and software help |
il y a 5 months |
|
Hi Diem - no, no, no and nope.... 🤣 Im going to mark this ... Dans le forum Hardware, firmware and software help |
il y a 5 months |
|
Thanks Eef - I had the extruder in pieces earlier and I doub... Dans le forum Hardware, firmware and software help |
il y a 5 months |
|
Quick update.... if I disconnect the PTFE tube from its con... Dans le forum Hardware, firmware and software help |
il y a 5 months |
|
Underextrusion issue Dans le forum Hardware, firmware and software help |
il y a 5 months |
|
Thanks W-Sand. I took the filament sensor apart today and d... Dans le forum Hardware, firmware and software help |
il y a 7 months |
|
That sounds promising….. I did some experiments today to ... Dans le forum Hardware, firmware and software help |
il y a 7 months |
|
@w sand - did you get to the bottom of the problem? I’m expe... Dans le forum Hardware, firmware and software help |
il y a 7 months |
|
OK - found the problem..... I noticed that within slicer, t... Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
Final test - Parked both heads. Changed slicer to print fro... Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
Update I parked tool 2 and loaded tool 1 before sending the ... Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
XL using wrong tool - settings? Dans le forum Hardware, firmware and software help |
il y a 8 months |
|
I just did a quick test with adding the 2 stage heat up proc... Dans le forum General discussion, announcements and releases |
il y a 5 years |
|
I think it has started since I last upgraded the f/w but Im ... Dans le forum General discussion, announcements and releases |
il y a 5 years |
|
Bed level before print leaving material on print bed Dans le forum General discussion, announcements and releases |
il y a 5 years |
|
I may have found the issue.
I was using octoprint on an o... Dans le forum Others (Archive) |
il y a 6 years |
|
Outer wall issue on circles...... Dans le forum Others (Archive) |
il y a 6 years |
