Aktywność
 
Notifications
Clear all
Keri
Keri
Grupa: PrusaLink-beta
Dołączył: 2016/05/17
Tytuł: Member
I kept the chimney in place, unscrewed the QSM-M5 connector ...

In forum Assembly and first prints troubleshooting

5 years temu
Thanks for the advice. I lowered the probe significantly an...

In forum Others (Archive)

8 years temu
Yes the Z goes from 0 to 1 which means that the port is work...

In forum Others (Archive)

8 years temu
how to test the probe

In forum Others (Archive)

8 years temu
Here is a video of my hot end in its current state. It does...

In forum Others (Archive)

8 years temu
Hi, I have been away from my printer and haven't been able ...

In forum Others (Archive)

8 years temu
Good ideas! Thank you. I will try them and reply

In forum Others (Archive)

8 years temu
Thermal Runaway

In forum Others (Archive)

8 years temu
James, Thinking about what you said made me realize that m...

In forum Others (Archive)

8 years temu
I do not have a solution, but I am having a thermal runaway ...

In forum Others (Archive)

8 years temu
I sliced it for PLA using Slic3r and tried printing it twice...

In forum Others (Archive)

8 years temu
I have about a dozen whistles that I have printed without a ...

In forum Others (Archive)

8 years temu
Layer Shifting

In forum Others (Archive)

8 years temu
Can someone explain exactly what you mean by pulley screws? ...

In forum Others (Archive)

8 years temu
Your directions are SPOT ON to the ones on the website. Goo...

In forum Others (Archive)

9 years temu
I replaced the nozzle yesterday. It looks like the Heat Bre...

In forum Others (Archive)

9 years temu
Hi! I had the same issue with the Z axis adjust going from 0...

In forum Others (Archive)

9 years temu
yes, I did heat the nozzle before removing it. I think the...

In forum Others (Archive)

9 years temu
This is what it looks like right now. I can't get it back o...

In forum Others (Archive)

9 years temu
It was a 5 amp fuse, luckily I had an extra in the garage. ...

In forum Others (Archive)

9 years temu
Strona 1 / 2
Share: