Prusa3D Forum

Notifications

Clear all

Ken Cole

Groupe: Enregistré

A(ont) rejoint: 2017/12/05

Active Member

	For what it's worth, the MicroSwiss heatbreak appears to hav... Dans le forum Hardware, firmware and software help	il y a 7 years
	FYI, I have installed the microswiss heat-break and printed ... Dans le forum Hardware, firmware and software help	il y a 7 years
	On the left, RC1. On the right, RC2. There is an improvemen... Dans le forum General discussion, announcements and releases	il y a 7 years
	Per this thread: I noticed that the extrusion inconsistency... Dans le forum General discussion, announcements and releases	il y a 7 years
	No, it won't. That's simply what I set it to. The resulting... Dans le forum Hardware, firmware and software help	il y a 7 years
	Print Quality, and a possible clue Dans le forum Hardware, firmware and software help	il y a 7 years
	My sample, 20mm cube, 1-layer walls, vase mode, with Prusa P... Dans le forum General discussion, announcements and releases	il y a 7 years
	I've been working through the dreaded extruder clicking for ... Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.8 K Messages

12 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé