Prusa3D Forum

Notifications

Clear all

Ken Cole

Skupina: Registrovaný

Přidal se: 2017/12/05

Active Member

	For what it's worth, the MicroSwiss heatbreak appears to hav... In forum Hardware, firmware and software help	před 7 years
	FYI, I have installed the microswiss heat-break and printed ... In forum Hardware, firmware and software help	před 7 years
	On the left, RC1. On the right, RC2. There is an improvemen... In forum General discussion, announcements and releases	před 7 years
	Per this thread: I noticed that the extrusion inconsistency... In forum General discussion, announcements and releases	před 7 years
	No, it won't. That's simply what I set it to. The resulting... In forum Hardware, firmware and software help	před 7 years
	Print Quality, and a possible clue In forum Hardware, firmware and software help	před 7 years
	My sample, 20mm cube, 1-layer walls, vase mode, with Prusa P... In forum General discussion, announcements and releases	před 7 years
	I've been working through the dreaded extruder clicking for ... In forum Others (Archive)	před 7 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.2 K Příspěvky

22 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed