Prusa3D Forum

Notifications

Clear all

Ken

Groupe: Enregistré

A(ont) rejoint: 2019/07/17

Eminent Member

	Sorry, I did not know what 3MF was. I zipped and attached o... Dans le forum How do I print this? (Printing help)	il y a 2 years
	F3D file attached. Yes, it was printing overnight where the ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Sorry, I mis-typed the temp. The temp I'm using is actually... Dans le forum How do I print this? (Printing help)	il y a 2 years
	RE: Cracks in sidewall of print. Dans le forum How do I print this? (Printing help)	il y a 2 years
	Cracks in sidewall of print. Dans le forum How do I print this? (Printing help)	il y a 2 years
	Got it. Thanks much for the info. Dans le forum PrusaSlicer	il y a 2 years
	So where is the "Flow" specified? Dans le forum PrusaSlicer	il y a 2 years
	Flow Confusion Dans le forum PrusaSlicer	il y a 2 years
	Thank you for making this clear. All my prior experience co... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Why did I not need supports for a 5.9mm gap Dans le forum How do I print this? (Printing help)	il y a 3 years
	Here is my latest try. Zip file attached. Male-Slid... Dans le forum PrusaSlicer	il y a 4 years
	The whole piece is only 6 mm tall, with an arc radius of 1.5... Dans le forum PrusaSlicer	il y a 4 years
	Problem with supports Dans le forum PrusaSlicer	il y a 4 years
	Thank you. I now see what it does. It does not do what I w... Dans le forum PrusaSlicer	il y a 4 years
	Variable Layer, Mouse Wheel Dans le forum PrusaSlicer	il y a 4 years
	Hi Neo, I have been experimenting for days and here is where... Dans le forum PrusaSlicer	il y a 5 years
	Where do I find the "Support Interface Drop-down"? Dans le forum PrusaSlicer	il y a 5 years
	The strings don't sag, they are just not attached to the str... Dans le forum PrusaSlicer	il y a 5 years
	Hi Neo, I ran the print with your settings and it reduced th... Dans le forum PrusaSlicer	il y a 5 years
	Hi Neo, I really appreciate your help. The printer is runn... Dans le forum PrusaSlicer	il y a 5 years

Page 1 / 2 Suivant

Statistiques du forum

585 Forums

67.9 K Sujets

476.1 K Messages

14 En-ligne

75.5 K Membres

Le dernier des messages: Calibration fails Notre nouveau membre: klong Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé