Prusa3D Forum

Notifiche

Cancella tutti

kemp.b

Gruppo: Registrato

Registrato: 2017/01/07

Active Member

	Well, I'm a beginner at this (which is apparent in my model)... Nel forum Print tips (Archive)	8 years fa
	Model too thin for Slic3r? Nel forum Print tips (Archive)	8 years fa
	If you're not already doing so, feel with your hand on the b... Nel forum Prusa i3 kit (Archive)	8 years fa
	Why can't you just lower your probe? As long as it's higher ... Nel forum Prusa i3 kit (Archive)	8 years fa
	Guys, thanks for your advice. Last night, I ended up finally... Nel forum Prusa i3 kit (Archive)	8 years fa
	Jeff, thanks for the advice. I'll try readjusting the extrud... Nel forum Prusa i3 kit (Archive)	8 years fa
	Okay, after messing with the pinda probe height over the las... Nel forum Prusa i3 kit (Archive)	8 years fa
	I live-set the Z-axis to -.900mm and still am not getting a ... Nel forum Prusa i3 kit (Archive)	8 years fa
	Well, no luck. Tonight, I made sure the bearing springs were... Nel forum Prusa i3 kit (Archive)	8 years fa
	Jeff, thanks for the very helpful post! I'll do these very t... Nel forum Prusa i3 kit (Archive)	8 years fa
	First print via v2calibration gcode - no bueno Nel forum Prusa i3 kit (Archive)	8 years fa

Statistiche Forum

565 Forum

63.6 K Discussioni

446.2 K Post

22 Online

69 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso