Prusa3D Forum

Notifications

Clear all

kemp.b

Group: Registered

Joined: 2017/01/07

Active Member

	Well, I'm a beginner at this (which is apparent in my model)... In forum Print tips (Archive)	8 years ago
	Model too thin for Slic3r? In forum Print tips (Archive)	8 years ago
	If you're not already doing so, feel with your hand on the b... In forum Prusa i3 kit (Archive)	8 years ago
	Why can't you just lower your probe? As long as it's higher ... In forum Prusa i3 kit (Archive)	8 years ago
	Guys, thanks for your advice. Last night, I ended up finally... In forum Prusa i3 kit (Archive)	8 years ago
	Jeff, thanks for the advice. I'll try readjusting the extrud... In forum Prusa i3 kit (Archive)	8 years ago
	Okay, after messing with the pinda probe height over the las... In forum Prusa i3 kit (Archive)	8 years ago
	I live-set the Z-axis to -.900mm and still am not getting a ... In forum Prusa i3 kit (Archive)	8 years ago
	Well, no luck. Tonight, I made sure the bearing springs were... In forum Prusa i3 kit (Archive)	8 years ago
	Jeff, thanks for the very helpful post! I'll do these very t... In forum Prusa i3 kit (Archive)	8 years ago
	First print via v2calibration gcode - no bueno In forum Prusa i3 kit (Archive)	8 years ago

Forum Statistics

565 Forums

63.6 K Topics

446.2 K Posts

20 Online

69 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed