Prusa3D Forum

Notifications

Clear all

Kelly R. Johnson

Groupe: Enregistré

A(ont) rejoint: 2016/11/17

Active Member

	A short update - In order to rule out issues with filament b... Dans le forum How do I print this? (Printing help)	il y a 4 years
	i3 Mk2.5 - Significant quality issues over time Dans le forum How do I print this? (Printing help)	il y a 5 years
	UPDATE: I am a total goober. When I updated firmware last, I... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Y-axis distance between upright and front mounts Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Looks like this is the standard Z-Hop that's in the Slic3r p... Dans le forum Others (Archive)	il y a 7 years
	I just ran into the shifting issue (along the Y-axis, toward... Dans le forum Others (Archive)	il y a 7 years
	I run into the same issues, but realistically I think we can... Dans le forum Improvements (Archive)	il y a 7 years
	Current update: The printer is working again. I replaced th... Dans le forum Others (Archive)	il y a 7 years
	I've pulled the hotend and replaced the PTFE tube - but brok... Dans le forum Others (Archive)	il y a 7 years
	The filament is just loose scrap at this point, leftovers fr... Dans le forum Others (Archive)	il y a 7 years
	Current update: The extruder body has been replaced, wires... Dans le forum Others (Archive)	il y a 7 years
	All is not well in i3 land - I ran another test print that... Dans le forum Others (Archive)	il y a 7 years
	I ran a new XYZ calibration yesterday and it completed norma... Dans le forum Others (Archive)	il y a 8 years
	I've run into this a few times with various printers. Prehe... Dans le forum Others (Archive)	il y a 8 years
	Yes, I have - All OK. I run in high-power mode at all times... Dans le forum Others (Archive)	il y a 8 years
	Prints/layers shifting and failing Dans le forum Others (Archive)	il y a 8 years
	I can confirm that current shipments (delivered 01-JAN-17) d... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Statistiques du forum

559 Forums

62 K Sujets

438.7 K Messages

16 En-ligne

67.1 K Membres

Le dernier des messages: FYI on upgrading from MK3.9/MK4 to MK3.9S/MK4S Notre nouveau membre: Phoenix 3D Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé