|
When i got to it, it was cooled off, assumed it canceled, b... In forum Others (Archive) |
7 years ago |
|
Your thoughts? A failing wire? How to test for it? Wiggling... In forum Others (Archive) |
7 years ago |
|
i have had about 5 large prints fail in the last few days du... In forum General discussion, announcements and releases |
7 years ago |
|
they are all metric. and in the instructions:
3mm Allen k... In forum Others (Archive) |
7 years ago |
|
I doubt it. the mk2/mm is at 3.1.0, the mk3 section says mk... In forum General discussion, announcements and releases |
7 years ago |
|
I FOLLOWED THE PROCEDURE TO UPDATE TO 143e, tried a print ov... In forum General discussion, announcements and releases |
7 years ago |
|
you can try to update it to 134e which jo has posted here: In forum Others (Archive) |
7 years ago |
|
Whatever you changed in 143e, seems to be working for my Set... In forum General discussion, announcements and releases |
7 years ago |
|
theres like no stringing i can see. i didnt think of puttin... In forum Others (Archive) |
7 years ago |
|
get your print on! In forum General discussion, announcements and releases |
7 years ago |
|
the latest firmware(rc4_b143) it now unloads a bit, them mov... In forum Others (Archive) |
7 years ago |
|
im running RC4 B143 this morning, connected via usb with oct... In forum Others (Archive) |
7 years ago |
|
Slic3r Prusa Edition was updated to version 1.38.5(in driver... In forum Others (Archive) |
7 years ago |
|
ive had this a couple times a few prints ago. not sure what... In forum Others (Archive) |
7 years ago |
|
i just ran the XYZ cal, and it seems to be homing properly n... In forum Others (Archive) |
7 years ago |
|
bed leveling failed, sensor didnt trigger In forum Others (Archive) |
7 years ago |
|
In the assembly you probably pressed the belt all the way on... In forum Others (Archive) |
7 years ago |
|
my x axis belt is also forced to the front part of the idler... In forum Others (Archive) |
7 years ago |
|
my mk3 is finally on its way...cant wait In forum General discussion, announcements and releases |
7 years ago |
|
i would like to know also, as i will be using a pi3 b board ... In forum Others (Archive) |
7 years ago |
