Italiano
Forum
Utenti
keith.m10
Attività
 
Notifiche
Cancella tutti
keith.m10
keith.m10
Gruppo: Registrato
Registrato: 2017/10/07
Eminent Member
2
Profilo Attività
The rail drawing is located here:

Nel forum Others (Archive)

 7 years fa
I do not think you will find 12 volts on a 24 volt supplied ...

Nel forum Others (Archive)

 7 years fa
Make sure you have the Red and Black heat bed wires on the r...

Nel forum Others (Archive)

 7 years fa
I expect it is POM(Delrin) which does not need much if any l...

Nel forum Others (Archive)

 7 years fa
They may actually be related, as the current rush from the P...

Nel forum Hardware, firmware and software help

 7 years fa
Might try to add a small lip on the inside of the X idler th...

Nel forum Others (Archive)

 7 years fa
Most NEMA17 steppers are rated up to 80 C for allowable oper...

Nel forum Others (Archive)

 7 years fa
He reviewed the MK3 MMU unit they sent him I know, as I watc...

Nel forum Others (Archive)

 7 years fa
This is usually a result of the thermistor reading as a high...

Nel forum Others (Archive)

 7 years fa
You need to make sure you do not get a high temp threadlock ...

Nel forum Others (Archive)

 7 years fa
Remember the print bed is cold to the plastic coming out, so...

Nel forum Others (Archive)

 7 years fa
You have not installed the <board>boot loader for it t...

Nel forum Prusa i3 kit (Archive)

 7 years fa
The 12 volt supply gave away that it was not a MK3 since it(...

Nel forum Improvements (Archive)

 7 years fa
I as of about two weeks ago will no longer buy from Makergee...

Nel forum Others (Archive)

 7 years fa
Usually the heat damages/oxidizes the connector surface so i...

Nel forum Others (Archive)

 7 years fa
I have tried quite a few of the slicers programs out there a...

Nel forum Others (Archive)

 7 years fa
I ordered a kit last month. But I think I can assemble it, I...

Nel forum General discussion, announcements and releases

 7 years fa
Pagina 2 / 2
Condividi: