Deutsch
Foren
Mitglieder
keith.m10
Aktivität
 
Benachrichtigungen
Alles löschen
keith.m10
keith.m10
Gruppe: Registriert
Beigetreten: 2017/10/07
Eminent Member
2
Profil Aktivität
The rail drawing is located here:

Im Forum Others (Archive)

 Vor 7 years
I do not think you will find 12 volts on a 24 volt supplied ...

Im Forum Others (Archive)

 Vor 7 years
Make sure you have the Red and Black heat bed wires on the r...

Im Forum Others (Archive)

 Vor 7 years
I expect it is POM(Delrin) which does not need much if any l...

Im Forum Others (Archive)

 Vor 7 years
They may actually be related, as the current rush from the P...

Im Forum Hardware, firmware and software help

 Vor 7 years
Might try to add a small lip on the inside of the X idler th...

Im Forum Others (Archive)

 Vor 7 years
Most NEMA17 steppers are rated up to 80 C for allowable oper...

Im Forum Others (Archive)

 Vor 7 years
He reviewed the MK3 MMU unit they sent him I know, as I watc...

Im Forum Others (Archive)

 Vor 7 years
This is usually a result of the thermistor reading as a high...

Im Forum Others (Archive)

 Vor 7 years
You need to make sure you do not get a high temp threadlock ...

Im Forum Others (Archive)

 Vor 7 years
Remember the print bed is cold to the plastic coming out, so...

Im Forum Others (Archive)

 Vor 7 years
You have not installed the <board>boot loader for it t...

Im Forum Prusa i3 kit (Archive)

 Vor 7 years
The 12 volt supply gave away that it was not a MK3 since it(...

Im Forum Improvements (Archive)

 Vor 7 years
I as of about two weeks ago will no longer buy from Makergee...

Im Forum Others (Archive)

 Vor 7 years
Usually the heat damages/oxidizes the connector surface so i...

Im Forum Others (Archive)

 Vor 7 years
I have tried quite a few of the slicers programs out there a...

Im Forum Others (Archive)

 Vor 7 years
I ordered a kit last month. But I think I can assemble it, I...

Im Forum General discussion, announcements and releases

 Vor 7 years
Seite 2 / 2
Teilen: