Čeština
Fóra
Uživatelé
keith.m10
Aktivita
 
Notifications
Clear all
keith.m10
keith.m10
Skupina: Registrovaný
Přidal se: 2017/10/07
Eminent Member
2
Profile Aktivita
The rail drawing is located here:

In forum Others (Archive)

 před 7 years
I do not think you will find 12 volts on a 24 volt supplied ...

In forum Others (Archive)

 před 7 years
Make sure you have the Red and Black heat bed wires on the r...

In forum Others (Archive)

 před 7 years
I expect it is POM(Delrin) which does not need much if any l...

In forum Others (Archive)

 před 7 years
They may actually be related, as the current rush from the P...

In forum Hardware, firmware and software help

 před 7 years
Might try to add a small lip on the inside of the X idler th...

In forum Others (Archive)

 před 7 years
Most NEMA17 steppers are rated up to 80 C for allowable oper...

In forum Others (Archive)

 před 7 years
He reviewed the MK3 MMU unit they sent him I know, as I watc...

In forum Others (Archive)

 před 7 years
This is usually a result of the thermistor reading as a high...

In forum Others (Archive)

 před 7 years
You need to make sure you do not get a high temp threadlock ...

In forum Others (Archive)

 před 7 years
Remember the print bed is cold to the plastic coming out, so...

In forum Others (Archive)

 před 7 years
You have not installed the <board>boot loader for it t...

In forum Prusa i3 kit (Archive)

 před 7 years
The 12 volt supply gave away that it was not a MK3 since it(...

In forum Improvements (Archive)

 před 7 years
I as of about two weeks ago will no longer buy from Makergee...

In forum Others (Archive)

 před 7 years
Usually the heat damages/oxidizes the connector surface so i...

In forum Others (Archive)

 před 7 years
I have tried quite a few of the slicers programs out there a...

In forum Others (Archive)

 před 7 years
I ordered a kit last month. But I think I can assemble it, I...

In forum General discussion, announcements and releases

 před 7 years
Stránka 2 / 2
Share: