Prusa3D Forum

Notifications

Clear all

kashyap.s

Groupe: Enregistré

A(ont) rejoint: 2015/08/28

Active Member

	Hello Try this belt tension bracket, I designed it for the ... Dans le forum Improvements (Archive)	il y a 10 years
	Some of my prints Dans le forum Improvements (Archive)	il y a 10 years
	Hi I would check that the connections for the power supply... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hello I do have the anti vibration feet in addition to the ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Motor Noise Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hello At what value do you have your infill overlap? Thank... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Top Layer Problem Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hello Have you tried to control the printer through Pronter... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Stop Print Problem Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hello I was scrolling through your attachments and, I think... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hello Have you tried to re-flash the firmware? Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hello This is an awesome update to the printer, I also put ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Both the terminal blocks are as tight as they can be Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Yes sir I did. Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Thermistor has just shorted Resulting in the MinTemp Error Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	This is a link to the image of the cube that I printed : Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hello Yes sir the belts are nice and tight as instructed in... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Print is going in different places Dans le forum Prusa i3 kit (Archive)	il y a 10 years

Statistiques du forum

585 Forums

68.2 K Sujets

478 K Messages

13 En-ligne

76 K Membres

Le dernier des messages: Please allow cloud account storage of PrusaSlicer settings Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé