Čeština
Fóra
Uživatelé
JustMe
Aktivita
 
Notifications
Clear all
JustMe
JustMe
Skupina: Registrovaný
Přidal se: 2021/08/20
Active Member
1
Profile Aktivita
Thank you so much! That worked!

In forum PrusaSlicer

 před 11 months
Sorry for the duplicate! The forums software doesn't play ni...

In forum PrusaSlicer

 před 11 months
I know this topic is old and no one has replied to it but I'...

In forum PrusaSlicer

 před 11 months
I know this topic is old and no one has replied to it but I'...

In forum PrusaSlicer

 před 11 months
Even in Simple mode you have the choice of choosing in both ...

In forum PrusaSlicer

 před 5 years
Two places to set retraction

In forum PrusaSlicer

 před 5 years
Thanks, Neophyl, I chose the ignore and now I don't have it ...

In forum PrusaSlicer

 před 5 years
My woes continue. In the beginning of each file there are so...

In forum PrusaSlicer

 před 5 years
I tried the last file and it doesn't work correctly either. ...

In forum PrusaSlicer

 před 5 years
Ringarn67, I loaded the .emf file you've made with my settin...

In forum PrusaSlicer

 před 5 years
Well, I have to admit I have no idea how to make the 3mf fil...

In forum PrusaSlicer

 před 5 years
bobstro, I don't know what settings you want to see. I don't...

In forum PrusaSlicer

 před 5 years
Yes, slicer setting may/will change the gcode file but that ...

In forum PrusaSlicer

 před 5 years
No, I can't

In forum PrusaSlicer

 před 5 years
I wrote 'error' instead of 'arrow' in my above reply but I c...

In forum PrusaSlicer

 před 5 years
In the picture below I highlighted the line in question and ...

In forum PrusaSlicer

 před 5 years
Doing post processing is basically what I do when I use Note...

In forum PrusaSlicer

 před 5 years
Changing default gcode output

In forum PrusaSlicer

 před 5 years
Share: